Porsche Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.car insurance, auto insurance, auto, car, vehicle, insurance, quote, quotes, online, insurance，auto, autos, car, cars, vehicle, vehicles, used car, pre-owned car, pre-owned vehicle, used auto, used vehicle, rental，auto racing news, car racing news

P0480

P0480

Diagnosis information - DME V6 DFI Driver for fan control 1

WARNING:

Danger of injury:

If this fault occurs, the fan may already start when the ignition is switched on. The following points must be observed in order to exclude the risk of injury:

• Perform work on the fan only with the ignition switched off.

• Secure the ignition to prevent accidental switching on by other persons.

  
  

  WARNING:

  Danger of injury:

  In the following instructions, trial connection of a different fan is recommended as a test step. The following points must be observed in order to exclude the risk of injury:

• Fit the new fan so that no objects can become caught up in it (parts of the body, hair, clothing, tools, etc.)

• Only then connect the fan connector.

• Assign the task of switching on the ignition to another person

• When diagnosis has been completed, switch off the ignition and disconnect the connector of the new fan again NOTE:

Diagnosis monitors control of the fan module.

The DFI sends a request to the control unit integrated in the fan module via this line by means of a pulse-width-modulated ground signal. This request is acknowledged on the same line (feedback to the DFI control unit). The fan switches to emergency operating mode if this feedback is not received.

The fan module cannot be measured on the input side.

Diagnostic conditions

• Time after engine starts greater than 10 seconds
  
  

  Possible fault causes

• Open circuit in power supply line to fan module 1 (large / right)
• Open circuit in ground supply line to fan module 1 (large / right)
• Open circuit in the control line to fan module 1
• Short circuit to ground in control line to fan module 1
• Short circuit to B+ in control line to fan module 1
• Control unit of fan module 1 faulty
  
  

  Affected contacts on the DFI control unit connector

  
  
  Connector [B]:
• Contact 28
  
  

  Affected contacts on connector of fan 1

  
  
  Connector [A]:
• Contact 3
• Contact 1
• Contact 2
• Contact 4