Wednesday, 15 January 2020

2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 532

2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 532



Setpoint Definitions



P0967



Setpoint definitions



NOTE: The specified values and value ranges correspond to the OK state in each case.



Line test setpoints



Short circuit to B+:



- Setpoint voltage -0.5 V --> +0.5 V



Short circuit to ground:



- Setpoint resistance > 0.9 MOhm



Open circuit:



- Setpoint resistance < 2 Ohm



NOTE: The specified values apply only at an ambient temperature of approx. 20 锟斤拷C (68 锟斤拷F) (room temperature).



Pressure regulator setpoints



- Internal resistance > 3.7 --> < 6.4 Ohm



Diagnosis Information - PDK (Dual-Clutch Transmission)



P0967



Diagnosis information - PDK



Pressure regulator 2 (clutch), short circuit to B+



Diagnostic conditions



The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are



then tested and any faults are stored.



- Ignition on



- The following fault is not detected: P1831



- The following fault is not detected: P1839



Possible fault causes



- Line between pressure regulator 2 and PDK control unit, short circuit to B+



- Pressure regulator 2 faulty



- PDK control unit faulty



Fault setting conditions



- Internal current measurement, actuator solenoid R/P: current consumption = 0 mA



- Pressure regulator 2, control current > 850 mA



Fault effects



- Pressure regulator 2 switch-off



- Engaged gear is held until vehicle stops.



- Moving off possible only in 3rd gear



- Transmission limp-home indication in instrument cluster control unit



With P17AB



P0968



Diagnosis information - PDK



Pressure regulator 3 (lubrication pressure/cooling pressure), shunt



Diagnostic conditions



The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are



then tested and any faults are stored.



- Ignition on



- The following fault is not detected: P0968



- The following fault is not detected: P0970



- The following fault is not detected: P0971