Vehicle: All Technical Service Bulletins
Electrical - Power Distributor Spare Parts Requirements
Service
9
48/10 ENU 9789
The present document was valid at the time of print. A later version may be available online
Spare Parts Requirements: Lower Part of Power Distributor (luggage compartment) (48/10)
Model year:
2010
Vehicle Type:
Panamera S/Panamera Turbo
Equipment:
Vehicles without I-no. 750 (Re-integration model year A)
Concerns:
- Lower part of power distributor (referred to below as power distributor") (main fuse box in luggage compartment).
- Fuse element F1 (40 A/green) (referred to below as "fuse") (-arrow-).
Information:
Spare parts requirements for power distributor.
In the course of vehicle production for model year A (2010), it was necessary to change fuse F1 in the power distributor from 40 amp to 60 amp due to a wire harness change (-arrow-).
The date of introduction of the changes (wire harness, fuse) was mid-April 2010.
The modified power distributor (... with fuse F1/60 A) has the part number 970.610.303.01.
Spare parts requirements:
If a replacement power distributor is required for model year A (2010) vehicles with the old part number 970.610.303.00, the following applies:
^ Power distributors that are still in stock will be used up.
^ The power distributor part number 970.610.303.00 will still be valid.
^ Once existing inventory of the power distributors have been used up, the Parts Department will supply the following parts as replacement for
970.610.303.00::
- 1 x power distributor/... with fuse F1 60 A/yellow (970.610.303.01) - 1 x 40 A/green fuse (999.607.099.00) - 1 x M5 hexagon nut (900.084.122.02)
Action Required:
Concerns only model year A (2010)vehicles.
If a replacement power distributor is required, check that the vehicle does not have I-no. 750 (Re-integration model year A). If this is the case and given the fact that existing stocks of power distributors are being used up, you must check following delivery of the power distributor to see which power distributor version you have received. Fuse F1 will have to be replaced, depending on the version.
Work Procedure:
1 Check that the vehicle does not have I-no. 750 (Re-integration model year A) by entering the vehicle identification number under Vehicle
Information" in the PIWIS information system.
-----------------------------------------------------Page 1-----------------------------------------------------
2010 Porsche Panamera Turbo (970) V8-4.8L Turbo
If this is the case: --> 2.2
If this is not the case: --> 3.3
2 Vehicle without I-no. 750:
Order the power distributor with part number 970.610.303.00.
2.1 Following delivery or before installing the power distributor:
Given the fact that the existing stock of power distributors (part number index 00) is currently being used up, please use the part number or fuse F1 (--> Figure 1) until further notice to check which power distributor version you have received.
If the supplied power distributor has the part number index 00 and fuse F1 is 40 A/green: --> 2.2 If the supplied power distributor has the part number index 01 and fuse F1 is 60 A/yellow: --> 2.3
2.2 Install the power distributor, see 978919 Removing and installing power distributor (HSB). End of action required.
2.3 Before or during installation of the new power distributor, remove fuse F1160 A/green and install the supplied 40 A/yellow fuse (-arrow-), see
978919 Removing and installing power distributor (HSB). End of action required.
3 Vehicle with I-no. 750:
Order and install the power distributor with Part No.970.610.303.01, see --> 978919 Removing and installing power distributor (HSB). End of action required.
Parts Info:
970120, 970121, 970420, 970421, 970430, 970431
Model year 2010 C02, C36
-----------------------------------------------------Page 2-----------------------------------------------------