2010 Porsche Cayenne Turbo (9PA) V8-4.8L Turbo Page 1
Engine: Removal and Replacement
1001IN Securing V8 4.8l DFI engine on the mounting bracket
WM 1001IN Securing V8 4.8l DFI engine on the mounting bracket
Tools
Preliminary work
1. Lift the engine with a workshop crane. => 10 Lifting the engine with a workshop crane
Securing engine on assembly support
DANGER
Suspended load.
- Risk of serious crushing and injury
-> Do not work at or under a suspended load.
-> Never reach in between the engine and components during installation or removal.
-> Wear protective safety gear.
DANGER
Danger of injury from incorrect use of tools and from falling loads.
- Danger of crushing from heavy loads.
-> When working on the engine suspension, the engine must be appropriately secured against falling or lowering.
-> Never use defective lifting equipment (bent or damaged tools must not be used or repaired. Always replace these tools). Check tools for signs of damage before use.
-> Only use lifting equipment tested and approved by Porsche. Home-made and auxiliary constructions result in improper use and are dangerous. -> The transport eyebolt can only bear vertical traction with no side or transverse forces. Side loads (e.g. from chains or cables) will damage the
transport eyebolt, which must then be replaced. Extreme cases of improper use can break the transport eyebolt.
-> Tools and lifting equipment must always be used properly. Improper use or dangerous home-made constructions can break tools and result in falling loads.
-> Wear protective gloves.
Information
- Some repair jobs involve suspending the engine on a suitable assembly support.
2010 Porsche Cayenne Turbo (9PA) V8-4.8L Turbo Page 2
- Secure engine support engine support P 9676 on engine. To do this, use the four screws for mounting elements 9590 and tighten them. => Engine carrier Other figure => Crankcase on engine support (shown with inverted top section of crankcase of disassembled engine).
Engine carrier
Crankcase on engine support (shown with inverted top section of crankcase of disassembled engine)
- Move engine in front of the engine support (assembly support) using the workshop crane and guide in with the help of a second worker. Raise engine so that the engine can be eased in horizontally. => Engine crane and engine on assembly support
2010 Porsche Cayenne Turbo (9PA) V8-4.8L Turbo Page 3
Engine crane and engine on assembly support
3. Secure engine on assembly support. => Engine secured on assembly support
Engine secured on assembly support