Friday, 7 December 2018

2010 Porsche Cayenne S (9PA) V8-4.8L A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 21

2010 Porsche Cayenne S (9PA) V8-4.8L A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 21



Possible fault causes



- Short circuit to B+ in signal line



- Oxygen sensor faulty (short circuit to B+)



Affected contacts on the DME control unit connector



Connector [A]:



- Contact 45



- Contact 49



- Contact 50



Affected contacts on the oxygen sensor connector behind catalytic converter, bank 1:



- Contact 2



- Contact 3



- Contact 4



P0140



P0140



Diagnosis information - DME V8 DFI



Oxygen sensor behind catalytic converter, bank 1, open circuit



NOTE: Do not use contact spray on the oxygen sensor's plug connections as this will result in irreparable damage to the lines (blockage of



reference air duct).



NOTE: Do not interchange the oxygen sensor ahead of catalytic converter with the sensor behind the catalytic converter as this will result in



implausible fault entries.



Diagnostic conditions



- Engine at operating temperature



- then drive for 2 minutes



- Then engine idling > 30 seconds



Possible fault causes



- Open circuit in signal line and / or ground line of oxygen sensor



- Loose contact in connector



- Oxygen sensor behind catalytic converter, bank 1, faulty



Affected contacts on the DME control unit connector



Connector [A]:



- Contact 49



- Contact 50



Affected contacts on the oxygen sensor connector behind catalytic converter, bank 1:



- Contact 3



- Contact 4



P0141



P0141



Diagnosis information - DME V8 DFI



Heater circuit, oxygen sensor behind cat. converter, bank X



NOTE: Do not use contact spray on the oxygen sensor plug connections, as this may cause irreparable damage to the wiring (blocking the reference



air channels).



NOTE: Do not interchange the oxygen sensor ahead of catalytic converter with the sensor behind the catalytic converter as this will result in



implausible fault entries.



Diagnostic conditions



- Engine running



- Oxygen sensor heater control active > 60 seconds



- Lambda control active



- No driver fault of oxygen sensor stored



Possible fault causes



- Contact resistance between DME control unit and oxygen sensor heater behind catalytic converter, bank X