2010 Porsche Cayenne S (9PA) V8-4.8L A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 38
P0298
P0298
Diagnosis information - DME V8 DFI
Oil temperature stuck/implausibly high
Diagnostic conditions
- Coolant temperature > 50 锟斤拷C (122 锟斤拷F) for more than 60 s (stuck low)
- Coolant temperature < 70 锟斤拷C (158 锟斤拷F) (stuck high)
- Vehicle voltage > 9 V
- No fault entered for coolant temperature
- No fault entered for oil temperature sensor
- Engine running > 10 sec.
Possible fault causes
- Loose contact or corrosion on connectors or lines
- Short circuit between lines
- Oil cooler damaged or blocked
- Oil temperature sensor faulty
P0300
P0300
Diagnostic information - DME V8 DFI
Misfire detection Cylinder X
NOTE:
- The fault P0300 >>Misfire totals fault<< indicates that an exhaust-relevant misfire has been detected for at least 1 cylinder.
- An initial indication appears because the relevant cylinder(s) is/are also stored.
NOTE:
- Diagnosis detects uneven running for the specified cylinder.
- Uneven running is calculated from the expected and actual crankshaft acceleration due to combustion.
- Uneven running is interpreted as a misfire or valve lift fault, depending on type.
NOTE:
- A cycle of 1,000 crankshaft revolutions is evaluated for exhaust-relevant misfires.
- The cycle is 200 revolutions for misfiring rates that will damage the catalytic converter.
- The misfiring rates are compared with a threshold value.
- If the misfiring rate is greater than the threshold value, the fault is set.
- The >>Check Engine<< warning light flashes if the misfiring rate has the potential to cause permanent catalytic converter damage.
NOTE:
- It is possible that only one cylinder (or the cylinders of one bank) has/have exceeded the uneven running threshold for a fault entry.
- However, other cylinders may also be just below the level which would result in a fault entry.
NOTE:
- Sensor wheel adaptation is necessary only after control unit programming.
- It is only when this is done that misfires can be reliably detected by the DFI.
- For this purpose, it is necessary to accelerate three times in second gear and then to allow the vehicle to coast to a stop without changing gear,
braking or accelerating (overrun fuel cutoff phase).
- It is possible to establish whether adaptation has been performed by reading out [[Adaptation status]] under [[Actual values]] in the PIWIS
Tester.
Diagnostic conditions
- Engine temperature > -20 锟斤拷C (-4 锟斤拷F)
- Engine speed > 400 rpm 6,700 rpm
- No overrun condition
- No crankshaft sensor fault P0335, P0336, P0371 or P0373 detected
Possible fault cause
- Use of an engine-block heater
- Lines, power or ground supply faulty for electrical components listed below (loose contact, oxidation, etc.)
- Lines, power or ground supply faulty for DME (DFI) control unit (loose contact, oxidation, etc.)
- Wrong spark plug(s) installed
- Mechanical or electrical fault in spark plug(s)