Friday, 1 February 2019

2000 Porsche Boxster (986) F6-2.7L A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 764


WARNING: Test is carried out while driving. Have a second person operate the Porsche System Tester 2.



During the system test for small lift, the valves remain at small lift, regardless of the type of driving. Faulty switching conditions can be detected by



rough running, just like with misfire detection. If a valve is not switched to small lift, the fault type 'under limit' is recorded.



Several cylinders may be stored as faulty, although only 1 valve on one cylinder is faulty.



In order to guarantee safety during repairs, the flat-base tappets of the inlet valves of the entire cylinder bank should be replaced if a fault occurs.



A faulty flat-base tappet can be detected because the oxygen sensor F(R) for this cylinder bank enriches the mixture (F(R) > 1) during acceleration



with wide-open throttle - see drawing below. Difference from the other oxygen sensor > approx. 15 %. In the case of a fault, the flat-base tappets of



the inlet valves for the entire cylinder bank must be replaced.



1 - Select system test.



2 - Select 'Request small lift'.



If "Valve lift diagnosis not ready" appears, a fault may have been stored.



1. Erase the fault memory.



3 - Activate the system test with the key F8 immediately before acceleration with wide-open throttle. The message "Drive link active" then



appears.



NOTE: If 'Request small lift' appears, the valves remain at small lift, ie. the performance is reduced dramatically.



4 - Perform acceleration with wide-open throttle in 2nd gear, until "Valve lift diagnosis complete" (max. 4,000 rpm) appears.



At speeds above 4,000 rpm, misfires may be stored. Delete the fault memory and repeat the test.



NOTE:



- If a fault is detected, it is only recorded in the fault memory after 6,000 ignitions (at idling speed approx. 3 minutes waiting time).



- It is important to observe the oxygen sensor during acceleration with wide-open throttle or to record its behaviour with the data logger.



P1354



P1354



630 Valve lift control, cylinder 4 - above limit



Diagnosis conditions



- Speed between 5,280 and 6,520 rpm



- Load between 125 and 190 %



- Acceleration with wide-open throttle