- No fault in camshaft adjustment output stage
Possible fault cause
- Allocation of camshaft to inlet camshaft incorrect
Diagnosis/Troubleshooting
NOTE: This fault is stored if the engine was disassembled and the allocation of the camshaft to the inlet camshaft was incorrectly set.
Position of Camshaft In Relation to Crankshaft, Bank 2 - Above Limit
P1324
Position of Camshaft in Relation to Crankshaft, Bank 2 - Above Limit
Function
When the engine is started and the reference mark has been recognized, the control module adapts the camshaft signal with respect to the reference
mark, i.e. the software compensates for deviations from a fixed value by angle shifts. If these adaptation values reach their limits, the fault "timing
chain out of position" is recognized.
Diagnosis conditions
- Idle speed
- Reference mark recognized
- Engine speed between 600 rpm and 1200 rpm
- Engine temperature > 60 锟斤拷C
- No fault in camshaft position sensors
- Reference mark OK
- No fault in camshaft adjustment
- No fault in engine temperature
P1324 - P1340
NOTE:
- This fault can be stored only if the engine was disassembled and the allocation of the outlet camshaft to the inlet camshaft was incorrectly set.
- To adjust the camshafts, please refer to the 911 Carrera 996 Technical Information.
Position of Camshaft In Relation to Crankshaft, Bank 2 - Below Limit
P1324
Position of Camshaft in Relation to Crankshaft, Bank 2 - Below Limit
Function
When the engine is started and the reference mark has been recognized, the control module adapts the camshaft signal with respect to the reference
mark, i.e. the software compensates for deviations from a fixed value by angle shifts. If these adaptation values reach their limits, the fault "timing
chain out of position" is recognized.
Diagnosis conditions
- Idle speed
- Reference mark recognized
- Engine speed between 600 rpm and 1200 rpm
- Engine temperature > 60 锟斤拷C
- No fault in camshaft position sensors