3. Switch on the ignition.
The signal shown in the diagram opposite should appear:
4. Fully depress accelerator pedal.
The signal shown in the diagram opposite should appear:
2 Perform adaptation.
1. Switch on the ignition.
2. Wait one minute.
Do not press the accelerator.
3. Switch off the ignition for at least 10 seconds.
4. Read out the fault memory.
3 Check voltage supply to throttle position sensor.
1. Connect special tool 9637 to wiring harness (DME control module connector).
2. Connect voltmeter to pin III/10 (positive) and pin III/25.
Switch on the ignition.
Display: approx. 5 V
4 Check voltage values of throttle position sensor 2.
1. Connect special tool 9637.
2. Connect voltmeter to pin III/8 (positive) and pin III/25 (negative).
Switch on the ignition.
Display: approx. 4.0 - 4.4 V
Fully depress accelerator pedal.
Display: approx. 0.5 - 0.8 V
5 Check wiring from throttle part to DME control module for continuity or short circuit to B+ or ground.
NOTE: The wires to the throttle part are routed via connector X 59/2.
1. Separate disconnection point to throttle part.
2. Connect special tool 9637 to wiring harness
(DME control module connector).
3. Connect ohmmeter to disconnection point, pin 1, and special tool 9637, pin III/43.
Display: 0 - 5 ohms
4. Connect ohmmeter to disconnection point, pin 2, and special tool 9637, pin III/25.
Display: 0 - 5 ohms
5. Connect ohmmeter to disconnection point, pin 3, and special tool 9637, pin III/10.