2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 97
Diagnosis information - PDK
Clutch 1, implausible control pressure
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following faults are not detected: P0841, P0843, P181A
Possible fault causes
- Shunt in wiring harness
- Clutch faulty
- Hydraulics faulty
Fault setting conditions
- Actual pressure at clutch 1 < touchpoint + offset (1 bar)
- Actual pressure at clutch 1 < prefilling pressure + offset (0.6 bar)
Fault effects
- Open clutches 1 and 2
- Disengage all gears
- Moving off in 2nd gear
- Only gears 2, 4 and 6 are possible
- Transmission limp-home indication in instrument cluster control unit
Clutch 2, Implausible Control Pressure
P17B5
Diagnosis information - PDK
Clutch 2, implausible control pressure
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.
- Ignition on
- The following faults are not detected: P0846, P0848, P181B
Possible fault causes
- Shunt in wiring harness
- Clutch faulty
- Hydraulics faulty
Fault setting conditions
- Actual pressure at clutch 2 < touchpoint + offset (1 bar)
- Actual pressure at clutch 2 < prefilling pressure + offset (0.6 bar)
Fault effects
- Open clutches 1 and 2
- Disengage all gears
- Moving off in 2nd gear
- Only gears 1, 3, 5 and 7 are possible
- Transmission limp-home indication in instrument cluster control unit
Clutch 1 Remains Mechanically At Excessively High Pressure After Rapid Filling
P17B5
Diagnosis information - PDK
Clutch 1 remains mechanically at excessively high pressure after rapid filling
Diagnostic conditions
The control unit initially tests internal function sequences when the ignition is switched on (terminal 15). If they are OK, all diagnosable outputs are
then tested and any faults are stored.