2010 Porsche Panamera Turbo (970) V8-4.8L Turbo A L L Diagnostic Trouble Codes ( DTC ): P Code Charts Page 250
- Lambda control Active
- Mixture deviation per bank -10 % ... +10 %
--> See Actual values >L340 Upper fuel trim (FRAO) B1 + L350 Upper fuel trim (FRAO) B2<
(If there is NO longer any need for adaption in this area)
- Full-throttle acceleration, at:
- Engine speed 2,500 1/min --> 3,400 1/min
- 4. gear or higher
- Gear must be maintained
- No fault entered for : Lambda control
Possible fault causes
- Vacuum line (Vacuum modulator at intake pipe pipe) Faulty
- Shift solenoid valve for Vacuum modulator at intake pipe stuck (See [Information])
- Vacuum modulator at intake pipe Faulty [See [Information]]
- Flap stuck (open or Closed)
INFORMATION
- Entrainment of engine oil into the vacuum system due to a faulty mechanical vacuum pump can result in the specified consequential faults.
- In this case, the entire vacuum system for the accessories (without brake booster circuit) must be checked for oil entrainment.
- All vacuum lines, connectors and components of the vacuum system that are soiled with oil must be replaced.
Diagnostic function
- Normal triggering of the flap occurs at approx. 4,000 1/min ..
- Diagnosis is performed by means of active activation. at:
- approx. 2,500 ... 3,400 1/min
- The diagnosis checks whether deviation of the oxygen sensors is as expected upon activation. at:
- Result OK --> Diagnosis ended
- Result not OK --> Diagnosis is repeated; at:
- Result OK --> Diagnosis ended
- Result not OK --> Diagnosis is repeated; at:
- Result OK --> Diagnosis ended
- Result not OK --> Fault entry P065E
P0068
P0068
Diagnosis information - Control unit DME (DFI)
Mass air flow implausible
INFORMATION
One or more additional faults are entered that more precisely indicate the operating ranges in which the fault occurred.
- range near idle speed:
- P1069 + P1070 + P1071 + P1072 + P1073
- lower partial-load range:
- P1074 + P1075
- upper partial-load range:
- P1076 + P1077
Diagnostic conditions + Possible fault causes
-->refer to the respective document
Fault setting condition(s)
- Impermissibly large deviation of the measured air mass from the calculated air mass.
P0069
P0069
Diagnosis information - Control unit DME (DFI)
Intake manifold pressure sensor implausible