2.1. Fully insert both U-brackets into the rear of the center console as shown in Figure 2, arrow A. (The open side of the U-brackets point
downward.)
2.2. Position the hinge plate on the center console using the two locating studs as a guide. (Figure 2, arrow B). Using a 4.0 mm drill bit, drill two
holes through the center console and U-brackets, (arrow C) using the hinge plate as a drilling template. Vacuum up any drilling particles.
Note:
Ensure that the hinge plate and the U-brackets do not shift during the drilling process!
2.3. Rivet the hinge plate and the U-bracket together with the supplied pop-rivets. (Figure 3 arrows D) After riveting, ensure there is no free-play,
and that the installation is solid.
2.4. Re-assemble the center console cover.
2.5. Mount the lower section of the cover and the cover spring onto the center console using the supplied hinge pin Important: Insert the unmilled
(smooth) end of the hinge pin into cover first. Drive in pin with a 3 mm drift punch.
2.6. Mount the upper section of the cover to the lower cover with fastening screws.
Working Time:
DisclaimerTechnical Service Bulletin # 1/00 Date: 000421
Power Steering - Noisy Return Hose
Boxster
1/00
4895
Binder - 4, Running Gear
4-21-00
Power Steering Return Hose
Vehicle Type:
Boxster
Model Year:
As of 2000 (Y)
Concern:
Return line for power steering.
Information:
A power steering return line identified by a wrapped looking surface was installed on a limited amount of model year 2000 cars produced in