1. Remove the sun visor and place on a clean surface; refer to 911 Carrera Technical Manual, Group 6, Repair, 68 23 19 - Removing and
installing sun visors.
2. Unclip the vanity mirror from the sun visor with a suitable tool, for example, narrow plastic wedge, medium width slotted screwdriver, etc.;
refer to 911 Carrera Technical Manual, Group 6, Repair, 68 23 37 - Disassembling and assembling sun visor.
3. Cut through both wires approximately 1 - 2 cm from vanity mirror and strip the wires approximately 5 mm from the end.
4. Strip approximately 5 mm of insulation from the end of the wires on the new vanity mirror housing.
5. Fit a suitable piece of heat tubing on the sun visor or mirror side on the wires so the connection points can be insulated later.
6. Join the wires of the sun visor and the vanity mirror housing according to their color using suitable crimp connectors.
6.1 Insulate connection points with heat shrink tubing
7. Unclip the mirror insert from the previous vanity mirror with a small slotted screwdriver or narrow plastic wedge (Figure 2).
Caution!
Damage to the sun visor cover and the wires from the heating effect of the hot-air gun.
Observe the blower outlet direction of the hot-air gun during the shrinking procedure.
7.1 Clip in the mirror insert into the new vanity mirror housing.
8. Clip in the vanity mirror in the sun visor. Arrange the wires uniformly between vanity mirror and the sun visor.