wires and insulate with electrical tape.
3.14 Reconnect connector X1/2 and reattach it to it's mount.
3.15 Run the 4-wire long branch of the Litronic harness through the hole on the left side of the luggage compartment. Secure harness
grommet into the hole. Attach the harness to nearby components/wires with electrical tape or tie wraps, ensuring the wire cannot be
chafed.
3.16 Go to step 3.3.
3.21 Locate the white wire in the Litronic wiring harness. You must extend the white Litronic wire to connector X1/1, located on the left
side of the luggage compartment. Using a piece of white wire (0.35 sq.mm) in diameter, 4 feet long, strip one end and solder it to the
white Litronic harness wire. Insulate the connection with electrical tape.
3.22 Secure the extended white wire to the 4-wire long branch of the Litronic harness using electrical tape.
3.23 Run the 4-wire long branch of the Litronic harness through the hole on the left side of the luggage compartment, and run the extended
white wire to the white 21-pin connector (X1/1). Secure harness grommet into the hole. Attach the harness to nearby components/wires
with electrical tape or tie wraps, ensuring the wire cannot be chafed.
3.24 Detach and disconnect connector X1/1 on left wall of the luggage compartment.
3.25 Locate the white/black wire (1.5 sq.mm) from connector X1/1 (Pin 2, harness side). Strip back approx. 5 mm of the insulation.
3.26 Combine the white/black wire (1.5 sq.mm) of the vehicle harness with the extended white Litronic harness wire (0.35 sq.mm). Solder
the combined wires and insulate with electrical tape.
3.27 Reconnect connector X1/1 and reattach it to it's mount.
3.28 Go to step 3.3.
3.3 Run the 4-wire short branch of the Litronic harness through the hole on the right side of the luggage compartment. Secure harness
grommet into the hole.
3.4 Insert the 4 wires at each headlight into the supplied connectors according to the table shown.
3.5 Attach the harness in the wheel housings to nearby components/wires (Figure 5, Item A).
4. Install headlight control unit.
4.1 Connect the headlight control unit to the Litronic wiring harness.