- Ohmmeter on alarm system control module plug I, pin 5 and plug on driver side door lock pin 7
Display: < 5 ohms
- Voltmeter at alarm system control module plug I, pin 28 and ground
Voltmeter display: 0 Volts
- Ohmmeter at alarm system control module plug I, pin 28 and ground
Ohmmeter display: infinity
- Ohmmeter at alarm system control module plug I, pin 28 and plug on passenger side door lock pin 7
Ohmmeter display: < 5 ohms
4. Pull plug off switch for central locking
- Voltmeter at alarm system control module plug I, pin 29 and ground
Voltmeter display: 0 Volts
- Ohmmeter at alarm system control module plug I, pin 29 and ground
Ohmmeter display: infinity
- Ohmmeter at alarm system control module plug I, pin 29 and plug on switch for central locking pin 1
Ohmmeter display: < 5 ohms
- Voltmeter at alarm system control module plug I, pin 30 and ground
Voltmeter display: 0 Volts
- Ohmmeter at alarm system control module plug I, pin 30 and ground
Ohmmeter display: infinity
- Ohmmeter at alarm system control module plug I, pin 30 and plug on driver side door lock pin 3
Ohmmeter display: < 5 ohms
- Voltmeter at alarm system control module plug I, pin 32 and ground
Display: 0 Volts
- Ohmmeter at alarm system control module plug I, pin 32 and ground
Display: infinity
- Ohmmeter at alarm system control module plug I, pin 32 and plug on driver/passenger side door lock pin 3
Display: < 5 ohms
If no faults are detected in the wire, replace the door lock.
Test Point 46
TEST POINT 46
Airbag Signal Acknowledged
Fault Code 48
This fault is stored in the memory if the airbag control module transmits a signal to the alarm system control module after the airbag has been
triggered. This is a triggering log.
Procedure
1. Clear fault memory.