Test Point 3
TEST POINT 3
Inside Sensor On Left Does Not Function
Fault Code 3
This fault is stored in the following cases:
1. Open circuit in the supply lead to the inside sensor on left.
2. Short to B+ in the supply lead to the inside sensor on left.
3. Short to ground in the supply lead to the inside sensor on left.
Elimination:
- Delete fault memory, disengage reverse gear and switch off ignition. Then switch on ignition, engage reverse gear again and read out fault
memory.
- If the fault reappears, check plug on sensor for open circuit.
- If there is no open circuit, check for continuity with an ohmmeter from sensor connector pin 1 to pin 4 and pin 1 to pin 2. Continuity should
not be measured.
- If no short circuit can be detected, replace sensor.
Test Point 4
TEST POINT 4
Outside Sensor On Left Does Not Function
Fault Code 4
This fault is stored in the following cases:
1. Open circuit in the supply lead to the outside sensor on left.
2. Short to B+ in the supply lead to the outside sensor on left.
3. Short to ground in the supply lead to the outside sensor on left.
Elimination:
- Delete fault memory, disengage reverse gear and switch off ignition. Then switch on ignition, engage reverse gear again and read out fault
memory.
- If the fault reappears, check plug on sensor for open circuit.
- If there is no open circuit, check for continuity with an ohmmeter from sensor connector pin 1 to pin 4 and pin 1 to pin 2. Continuity should
not be measured.
- If no short circuit can be detected, replace sensor.
Test Point 5
TEST POINT 5
Control module Supply Voltage > 16.5 V or < 9 V
Fault Code 5
This fault is stored in the following cases:
1. Low vehicle voltage
2. If there is a fault in the generator
Elimination:
- Examine battery and generator voltages.
- Select Control module supply voltage and Sensor supply voltage under the menu item Actual values, and check the values with reverse gear
engaged and the engine running.
Control module supply voltage display: approx. 12 Volts
Sensor supply voltage display: approx. 8 Volts
- Delete fault memory, disengage reverse gear and switch off ignition. Then switch on ignition, engage reverse gear again and read out fault