2. Connect ohmmeter to plug, pin 23 and ground.
Plug of child seat not inserted.
Display: approx. 2 kOhms
Plug of child seat inserted.
Display: approx. 260 Ohms
3. Inspect the wiring harness to the triggering unit for pinches and chafing damage.
Test Point 8
Test point 8
Control module
Fault code >= 100
Replace the triggering unit.
Test Point 9
Test point 9
Unknown fault code
Fault code XXX
1. Inspect the ground points for corrosion.
2. Inspect the ignition on the secondary side.
3. Clear the fault memory.
Test Point 1
Test point 1
Ignition circuit, driver
Fault codes 04, 05, 20, 21, 36
1. Remove driver's airbag unit.
2. Attach the special tool 9516 instead of the airbag unit.
3. Clear the fault memory.
4. Check whether the fault appears again.
a. If the fault does not appear again, replace the airbag unit.
b. If the fault appears again, disconnect plug connection to the contact unit and attach special tool 9516/1.