Front left speed sensor, open circuit/ short to ground/ short to B+
DTC 4205
Wire/plug connection between control module and speed sensor not OK (open circuit, short to B+ or short to ground) or the speed sensor itself is
damaged.
Check the speed sensor wire and plug connection in the wheel area for damage (visual inspection).
- Check the speed sensor signal with the Porsche System Tester 2 via the Actual values menu (see test point 2/diagnostic trouble code 4206). If
no speed is displayed when the left front wheel is turned, check the wiring from the control module connector to the speed sensor (following
test step).
- Pull off control module connector. Measure internal resistance/continuity between PIN 6 and PIN 7 on the connector.
Nominal value 1600...1800 Ohms.
If the nominal value is not achieved, check wires and plug connection in the wiring from the front left speed sensor.
If the nominal value (1600...1800 Ohms) is not achieved although the wiring / plug connection is OK, replace the speed sensor.
- Check PIN 6 and PIN 7 of the control module connector inspection for deformation).
Test Point 7
Test point 7
Front right speed sensor, open circuit/ short to ground/ short to B+
DTC 4200
General procedure as for test point 6/diagnostic trouble code 4205.
- Speed sensor signal: Check with the Porsche System Tester 2 via the Actual values menu (call up front right wheel speed).
- Internal resistance/continuity between PIN 4 and PIN 5 on the control module connector.
Test Point 8
Test point 8
Rear right speed sensor, open circuit/ short to ground/ short to B+
DTC 4210
General procedure as for test point 6/diagnostic trouble code 4205.
- Speed sensor signal: Check with the Porsche System Tester 2 via the Actual values menu (call up rear right wheel speed).
- Internal resistance/continuity between PIN 1 and PIN 2 on the control module connector.
Test Point 9
Test point 9
Rear left speed sensor, open circuit / short to ground / short to B+
DTC 4215
General procedure as for test point 6/diagnostic trouble code 4205.
- Speed sensor signal: Check with the Porsche System Tester 2 via the Actual values menu (call up rear left wheel speed).
- Internal resistance/continuity between PIN 8 and PIN 9 on the control module connector.