Display: Battery voltage.
Note:
The positive lead (terminal 30) is fused in the distribution board with an 80 A fuse.
Test Point 11
TEST POINT 11
Voltage Failure During Alarm Output
Fault Code 11
Fault Effect: Interruption of alarm output
Procedure
1. Check battery.
2. Check the power supply of the alarm system control module.
Voltmeter at alarm system control module plug II, pin 1 (negative) and pin 7 (positive).
Display: Battery voltage.
Note:
The positive lead (terminal 30) is fused in the distribution board with an 80 A fuse.
Test Point 12
TEST POINT 12
Wrong Door Lock module
Fault Code 12
This fault concerns only USA vehicles. USA vehicles do not have the "Door secured" function.
Procedure
1. Check country coding
2. Check the driver's side / passenger's side door lock and, if necessary, replace it with a door lock for USA vehicles.
Test Point 13
TEST POINT 13
Left Door Secured But Not Locked
Fault Code 13
Procedure
1. Pull plug I off the alarm system control module.
2. Disconnect plug connection X 11 (driver's side).
3. Check the wire from the alarm system control module plug I pin 30 to the door lock for short to ground.
Ohmmeter at alarm system control module plug I, pin 30 and ground
Display: infinity
4. Check driver's side door lock switch contact.
Ohmmeter at plug connection X 11, pin A3 (sleeve side) and ground