Note:
Passenger side airbags are returned to a normal (activated) state when the child seat tongue is removed from the belt lock receptacle.
Warning!
Advise the customer that when using the Porsche child seat, if the passenger side airbag deactivation cannot be acknowledged by a flashing
airbag light upon vehicle start-up, or if the airbag light remains continuously lit (fault present), a child SHOULD NOT be placed in the child
restraint system! The vehicle should be immediately brought to an authorized Porsche dealer for repair!
Parts Information:
Tools Required:
Porsche System Tester 2 (PST2)
Torque wrench, up to 65 Nm (48 ft. lb.)
Torx socket, E 12
Installation:
1. Remove the seat rail covers and take out the floor mat. Remove the passenger seat.
2. Assemble the seat belt buckle with wire lead to the crossbar.
2.1 Locate the two wire connector taped to the wiring harness (Figure 2). Connect this lead to the connector of the crossbar buckle. Secure this
lead with adhesive tape.
2.2 Reinstall the passenger seat. Push the ends of the crossbar into the seat rails. When properly installed, the wire holder on the belt buckle
crossbar must face upward (Figure 3).
2.3 Fasten the crossbar and seat with the Torx screws (M10 X 35) included in the parts kit. Tighten the Torx bolts to 65 Nm (48 ft.lbs.).
Note:
Once the crossbar has been installed, the seat rail covers on the passenger side can no longer be installed.
Activation (enabling) of Child Seat Occupancy